Acta Univ. Agric. Silvic. Mendelianae Brun. 2014, 62(5), 939-944 | DOI: 10.11118/actaun201462050939

Comparing the Hydraulic Control of Tractor Three-point Hitch

Juraj Jablonický1, Pavel Máchal2, Anton Žikla1, Ján Kosiba1, Ľubomír Hujo1, Vladislav Hajdák1
1 Department of Transport and Handling, Faculty of Engineering, Slovak University of Agriculture in Nitra, Tr. A. Hlinku 2, 949 76 Nitra, Slovak Republic
2 Department of Project Management, Faculty of Regional Development and International Studies, Mendel University in Brno, Czech Republic

In this paper, there are monitored and compared the parameters of tractor three-point hitch control. Comparisons were carried out under laboratory conditions for two types of regulation. The first one was a standard mechanical and the second one was electro-hydraulic Bosch. Testing was performed on a test bench designed for the Department of Transport and Handling (Slovak University of Agriculture in Nitra). The results of measurements are evaluated statistically and shown in a graphical form.

Keywords: power control, mechanical hydraulic control, electro-hydraulic control
Grants and funding:

The research leading to these results has received funding from the European Community under project 26220220180: Building Research Centre "AgroBioTech". Supported by the Ministry of Education of the Slovak Republic, Project VEGA 1/0857/12 "Reduction of unfavourable impacts of agricultural and transport machinery on the environment".

Published: December 2, 2014  Show citation

ACS AIP APA ASA Harvard Chicago IEEE ISO690 MLA NLM Turabian Vancouver
Jablonický, J., Máchal, P., Žikla, A., Kosiba, J., Hujo, Ľ., & Hajdák, V. (2014). Comparing the Hydraulic Control of Tractor Three-point Hitch. Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, 62(5), 939-944. doi: 10.11118/actaun201462050939
Share...
Download citation
  • BibTeX (.bib)
  • Bookends (.ris)
  • EasyBib (.ris)
  • EndNote (.enw)
  • EndNote 8 (.xml)
  • ISI WoS (.isi)
  • Medlars (.medlars)
  • Mendeley (.ris)
  • MODS (.xml)
  • Papers (.ris)
  • RefWorks (.txt)
  • RefManager (.ris)
  • RIS (.ris)
  • MS Word (.xml)
  • Zotero (.ris)
    • Open full article

    References

    1. BENTAHER, H., HAMZA, E., KANTCHEV, G., MAALEJ, A., ARNOLD, W. 2008. Three-point hitch-mechanism instrumentation for tillage power optimization. Biosystems engineering 100, 24-30. DOI: 10.1016/j.biosystemseng.2008.01.008 Go to original source...
    2. ČUPERA, J., BAUER, F., SEVERA, L., TATÍČEK, M. 2011. Analysis of force effects measured in the tractor three-point linkage. Research in Agricultural Engineering, 57(3): 79-87. Go to original source...
    3. ČUPERA, J., ŠMERDA, T. 2010. Influence of top link length of three-point hitch on performance parameters of ploughing set. Research in Agricultural Engineering, 56(3): 107-115. Go to original source...
    4. MAJDAN, R., TKÁČ, Z., ABRAHÁM, R., STANČÍK, B., KUREKOVÁ, M., PAULENKA, R. 2013. Effect of ecological oils on the quality of materials of hydraulic pump components. In: Advanced Materials Research, 801(special iss.): 1-6. DOI: 10.4028/www.scientific.net/AMR.801.1 Go to original source...
    5. MÁCHAL, P., MAJDAN, R., TKÁČ, Z., STANČÍK, B., ABRAHÁM, R., ŠTULAJTER, I., ŠEVČÍK, P., RAŠO, M. 2013. Design and verification of additional filtration for the application of ecological transmission and hydraulic fluids in tractors. Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis, 61(5): 1305-1311. DOI: 10.11118/actaun201361051305 Go to original source...
    6. PRASANNA KUMAR, G. V. 2012. Development of a computer program fo the path generation of tractor hitch points. Biosystems engineering, 113: 272-283. DOI: 10.1016/j.biosystemseng.2012.09.004 Go to original source...
    7. PÁLTIK, J., FINDURA, P., MAGA, J., KORENKO, M., ANGELOVIČ, M. 2007. Poľnohospodárske stroje: skúšanie, konštrukcia, použitie (I. časť). 1. vyd. Nitra: Slovenská poľnohospodárska univerzita v Nitre, 190.
    8. PONIČAN, J., KORENKO, M. 2008. Stroje pre rastlinnú výrobu: stroje na zber krmovín, zrnín, ľanu, zemiakov, zeleniny a ovocia. 1. vyd. Nitra: Slovenská poľnohospodárska univerzita v Nitre, 248.
    9. PORTEŠ, P., BAUER, F., ČUPERA, J. 2013. Laboratory-experimental verification of calculation of force effects in tractor's three-point hitch acting on driving wheels. Soil & Tillage Research, 128: 81-90. DOI: 10.1016/j.still.2012.10.007 Go to original source...
    10. TKÁČ, Z., DRABANT, Š., MAJDAN, R., CVÍČELA, P. 2007a. Design and realisation of testing device for laboratory tests of hydrostatic pumps. In: Trends in Agricultural Engineering 2007: 3rd international conference TAE 2007. Prague, Czech Republic, CZU: 450-454.
    11. TKÁČ, Z., DRABANT, Š., MAJDAN, R., CVÍČELA, P. 2008. Testing stands for laboratory tests of hydrostatic pumps of agricultural machinery. In: Research in agricultural engineering, 54(4): 183-191. Go to original source...

    This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License (CC BY NC ND 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.


    Return to the content