Acta Univ. Agric. Silvic. Mendelianae Brun. 2017, 65(4), 1317-1322 | DOI: 10.11118/actaun201765041317

Monitoring of Changes Signal Acoustic Emission Signals Using Waveguides

Jaroslav Začal1, Petr Dostál1, Michal Šustr1, David Dobrocký2
1 Department of Technology and Automobile Transport Faculty of AgriSciences, Mendel University in Brno Zemědělská 1, 613 00 Brno, Czech Republic
2 Department of Engineer Technologies, Faculty of Military Technology, University of Defence in Brno, Kounicova 156/65, 662 10 Brno, Czech Republic

This paper is focused on possibilities of acoustic emission (AE) signal detection from material surface through waveguide for commonly used piezoelectric sensors. It also considers the experimental study of enhanced detection of occurrence of signal guided through waveguide corpus, its changes and deformities. Aim of this work is verification of several waveguide setup possibilities for maximization of AE signal detection in practice. For this purpose, multiple waveguide setups were manufactured from stainless steel and aluminium alloy. Hsu-Nielson pen test was utilized for signal actuation. Results demonstrate the differences between measured AE signal with and without employment of waveguide (changes in signal course through different materials and shapes), as well as magnitude of signal dampening and amplification necessary for veritable signal interpretation. Measurements were conducted on agglomerated composite of medium density fibreboard (MDF).

Keywords: acoustic emission, acoustic waveguide, non-destructive test
Grants and funding:

The research has been supported by the project No. 201613: Acoustic Detector of Plant Stress "ADOPS"; financed by TAČR GAMA TG02010074.

Published: September 1, 2017  Show citation

ACS AIP APA ASA Harvard Chicago IEEE ISO690 MLA NLM Turabian Vancouver
Začal, J., Dostál, P., Šustr, M., & Dobrocký, D. (2017). Monitoring of Changes Signal Acoustic Emission Signals Using Waveguides. Acta Universitatis Agriculturae et Silviculturae Mendelianae Brunensis65(4), 1317-1322. doi: 10.11118/actaun201765041317
Download citation

References

  1. ČERNY, M., MAZAL, P. and FILIPEK, J. 2008. Sensing of the acoustic signal by waveguides. Acta univ. agric. et silvic. Mendel. Brun., 61(1): 43 - 54. Go to original source...
  2. KREIDL, M., and ŠMÍD, R. 2006 Technical diagnostics. 1st Edition. Prague: BEN technical literature. 408 p.
  3. MURAVIN, G., MURAVIN, B. and BEILIN, D. 2011. Application of quantitative acoustic emission method for non-destructive inspection of metal and reinforced concrete structures. J. Sci. Isr.-Technol. Adv., 13(2 - 3): 1 - 292.
  4. MILLER, R. K. and HILL, E. K. 2008. Acoustic emission testing. 3rd Edition. Columbus: American Society for Nondestructive Testing. 446 p.
  5. PAZDERA, L., SMUTNY, J. and MAZAL, P. 2004. Utilization of acoustic emission method in endpoint loaded materials and construction. Brno: VUT.
  6. SRIWONGRAS, P. and DOSTÁL, P. 2015. Monitoring of water stress condition in maize by using acoustic emission technique. In: MendelNet-Proceedings of International PhD Students Conference. November 11 and 12, 2015, Brno, Czech Republic. Brno: Mendel University.
  7. ÚNMZ. 2000. Nedestruktivni zkoušeni - Terminologie. ČSN EN 1330 - 9. Prague: The office for Standards, Metrology and Testing.
  8. ÚNMZ. 2002. Nedestruktivni zkoušeni - akusticke emise - všeobecné zásady. ČSN EN 13554. Prague: The Office for Standards, Metrology and Testing.

This is an open access article distributed under the terms of the Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License (CC BY NC ND 4.0), which permits non-comercial use, distribution, and reproduction in any medium, provided the original publication is properly cited. No use, distribution or reproduction is permitted which does not comply with these terms.