Acta Univ. Agric. Silvic. Mendelianae Brun. 2015, 63, 9-13

https://doi.org/10.11118/actaun201563010009
Published online 2015-03-14

Detection of Corrosion Resistance of Components in Cyclic Salt Spray

Štefan Álló1, Vladimír Kročko1, Tamás Ibriksz2, Jan Mareček3

1Department of Quality and Engineering Technologies, Faculty of engineering, Slovak University of Agriculture in Nitra, Tr. A. Hlinku 2, 949 76 Nitra, Slovak Republic
2Department of Materials Science and Technology, Faculty of Engineering Sciences, Széchenyi István University, Egyetem square 1, 9026 Győr, Hungary
3Department of Agricultural, Food and Environmental Engineering, Faculty of Agronomy, Mendel University in Brno, Zemědělská 1, 613 00 Brno, Czech Republic

The aim of this research is, to investigate the influence of two types of cyclic salt spray tests on parts surface treated with galvanizing.
On the selected components was performed the method Zn-Ni surface treating on the bath line. Subsequently were the components embedded in the corrosion chamber, where was performed two types of cyclic salt test. In the first test was performed 4 hour salt spray, 8 hours drying, 60 hours condensation and 24 hours drying. Once cycle lasted 96 hours, and it was repeated 4 times. During the second test was performed 2 hours salt spray, 2 hours condensation. The cycle was repeated 4 times, that means 96 hours. After the cycle was performed 72 hours free relaxation in the corrosion chamber, on 20–25 °C temperature.
As the research showed, after the cyclic salt spray was no red corrosion on the selected components. The white corrosion appeared only slightly.

Funding

The research was performed receiving support from the TÁMOP-4.2.2.A-11/1/KONV-2012-0029 project “Development for the automotive industry”.

References

6 live references